<!--end title--!>

Thorens HX-8000 Belt FRX 35.1
Thorens TD-121 Belt FR 5.9
Thorens TD-121 Belt FRY 12.0
Thorens TD-124 Belt FRM 12.1
Thorens TD-125 Belt FR 20.0
Thorens TD-134 Belt FRM 12.7
Thorens TD-135 Belt FRM 12.7
Thorens TD-145 Belt FR 20.0
Thorens TD-150/MkII/AB Belt FRX 20.7
Thorens TD-160 Belt FR 20.0
Thorens TD-165/C Belt FR 20.0
Thorens TD-166 MkII FRZ 19.6
Thorens TD-184 Belt FRM 11.7
Thorens TD-574 Belt FR 20.0 <!--begin foot--!>

If your turntable is not listed, first look for a close match in model number. If that model's belt doesn't look like a match, then take careful measurements of your old belt's inside circumference, width and thickness.

Make the measurements with the belt lying flat and unstretched.  Use a paperclip to mark your starting point.  Measure in inches to match model; one inch=25.4mm.  Also, make note of how loose the old belt is while installed in the turntable.  Does it slip?  How much side-to-side deflection is there in the open section between the spindle and the platter?   Depending on how badly stretched out your old belt is, deduct 5 to 10 percent from the circumference.  If the belt is broken or missing, use a piece of string (wrapped without slack, but not stretched) to measure the proper circumference.  Either email me the measurements or browse available belt selection to find a suitable replacement.