<!--end title--!>

Realistic 13-1045 (RC0002)	Idler Wheel IW11	Special Order
Realistic 13-1130	Idler Wheel IW11	Special Order
Realistic 13-1175	Idler Wheel IW08	Special Order
Realistic 13-1175 (RC0002)	Idler Wheel IW11	Special Order
Realistic 13-1177	Idler Wheel IW11	Special Order
Realistic 42-2512	Idler Wheel IW11	Special Order
Realistic 42-2572	Idler Wheel IW11	Special Order
Realistic 42-2901	Idler Wheel IW11	Special Order
Realistic 53883	Idler Wheel IW17	Special Order
Realistic 58220	Idler Wheel IW11	Special Order
Realistic LAB-50	Belt FRM 15.2	In Stock $10.00
Realistic LAB-56	Belt FRM 14.2	Special Order
Realistic LAB-65	Belt FRX 15.2	In Stock $10.00
Realistic LAB-100	Belt FRM 15.2	In Stock $10.00
Realistic LAB-220	Belt FRM 14.7	In Stock $10.00
Realistic LAB-250	Belt FR 23.6	In Stock $10.00
Realistic LAB-300	Belt FRX 25.0	In Stock $10.00

<!--begin foot--!>

IW08 ID=.153 in. OD=2.015 in. C/S=.409 in.

IW11 ID=.153 in. OD=1.892 in. C/S=.313 in.

<!--begin foot--!>

If your turntable is not listed, first look for a close match in model number. Or, take careful measurements of your old belt's inside circumference, width and thickness.

Make the measurements with the belt lying flat and unstretched.  Use a paperclip to mark your starting point.  Measure in inches to match model; one inch=25.4mm.  Also, make note of how loose the old belt is while installed in the turntable.  Does it slip?  How much side-to-side deflection is there in the open section between the spindle and the platter?   Depending on how badly stretched out your old belt is, deduct 5 to 10 percent from the circumference.  If the belt is broken or missing, use a piece of string (wrapped without slack, but not stretched) to measure the proper circumference, and then deduct 10 percent to allow the new belt to stretch into place.  Go to the Belt Specifications Chart to find a suitable replacement.