Replacement Belts for Montgomery Ward Turntables Back to Belts Index Belt Specifications Chart TT Basics Home Page
<!--end title--!>
| Montgomery Ward A-110684/A | Belt FR 14.7 | Special Order | Montgomery Ward GEN-6310 | Belt FRY 10.7 | Special Order | Montgomery Ward GEN-6318A | Belt FRM 10.5 | Special Order | Montgomery Ward GEN-6319A | Belt FRY 10.7 | Special Order | Montgomery Ward GEN-6330A | Belt FRM 8.6 | Special Order | Montgomery Ward GEN-6330A | Belt FRX 10.5 | Special Order | Montgomery Ward GIM-2042A | Idler Wheel IW05 | Special Order | Montgomery Ward GMJ-2020A | Belt FRM 9.7 | Special Order | Montgomery Ward GMJ-2023 | Belt FRM 9.7 | Special Order | Montgomery Ward GMJ-2047D | Belt FRM 9.7 | Special Order | Montgomery Ward GMJ-2058D | Belt FRM 9.7 | Special Order | Montgomery Ward GMJ-2087F | Belt FRM 9.7 | Special Order | Montgomery Ward GMJ-2130A | Belt FRM 9.7 | Special Order | Montgomery Ward GMJ-2133B | Belt FRM 9.7 | Special Order | Montgomery Ward GMJ-2209A | Belt FRM 9.7 | Special Order | Montgomery Ward GMJ-2222B | Belt FRM 9.7 | Special Order | Montgomery Ward GMJ-2229 | Belt FRM 9.7 | Special Order | Montgomery Ward GMJ-2230A | Belt FRM 9.7 (2) | Special Order | Montgomery Ward GMJ-2290A | Belt FRM 9.7 | Special Order | Montgomery Ward GMJ-2290A | Belt FRM 10.5 | Special Order | Montgomery Ward GMJ-2341A | Belt FRM 9.7 | Special Order | Montgomery Ward GMJ-2941A | Belt FRM 9.7 | Special Order |
| IW05
ID=.123 in. OD=1.885 in. C/S=.557 in. |
If your turntable is not listed, first look for a close match in model number. Or, take careful measurements of your old belt's inside circumference, width and thickness.
Make the measurements with the belt lying flat and unstretched. Use a paperclip to mark your starting point. Measure in inches to match model; one inch=25.4mm. Also, make note of how loose the old belt is while installed in the turntable. Does it slip? How much side-to-side deflection is there in the open section between the spindle and the platter? Depending on how badly stretched out your old belt is, deduct 5 to 10 percent from the circumference. If the belt is broken or missing, use a piece of string (wrapped without slack, but not stretched) to measure the proper circumference, and then deduct 10 percent to allow the new belt to stretch into place. Go to the Belt Specifications Chart to find a suitable replacement.