Replacement Belts for Fisher Turntables Back to Belts Index Belt Specifications Chart TT Basics Home Page
<!--end title--!>
| Fisher 37-13001 | Belt FRX 15.2 | In Stock $10.00 |
| Fisher 320XA | Belt FRX 15.2 | In Stock $10.00 |
| Fisher MC-3015 | Belt FRZ 25.0 | In Stock $10.00 |
| Fisher MC-4026 | Belt FRM 14.7 | In Stock $10.00 |
| Fisher MT-32 | Belt FRZ 25.0 | In Stock $10.00 |
| Fisher MT-35 | Belt FRX 23.6 | In Stock $10.00 |
| Fisher MT-100/C | Belt FRY 25.0 | In Stock $10.00 |
| Fisher MT-101 | Belt FRY 25.0 | In Stock $10.00 |
| Fisher MT-730 | Belt FRY 23.6: Unavailable, substitute FRX 23.6 | In Stock $10.00 |
| Fisher MT-730 | Belt SCX 4.3 | Special Order |
| Fisher MT-750 | Belt SCQ 3.0 | Special Order |
| Fisher MT-6010 | Belt FRZ 25.0 | In Stock $10.00 |
| Fisher MT-6020 | Belt FRZ 25.0 | In Stock $10.00 |
| Fisher MT-6030 | Belt FRZ 25.0 | In Stock $10.00 |
| Fisher MT-6114 | Belt FR 23.6 | In Stock $10.00 |
| Fisher MT-6115 | Belt FRX 23.6 | In Stock $10.00 |
| Fisher MT-6117 | Belt FR 23.6 | In Stock $10.00 |
| Fisher MT-6118 | Belt FR 23.6 | In Stock $10.00 |
| Fisher MT-6210 | Belt FR 23.6 | In Stock $10.00 |
| Fisher MT-6211 | Belt FR 23.6 | In Stock $10.00 |
| Fisher MT-6310 | Belt FR 23.6 | In Stock $10.00 |
| Fisher MT-6410 | Belt FR 23.6 | In Stock $10.00 |
| Fisher TT-4191-028 | Belt FRZ 25.0 | In Stock $10.00 |
| Fisher TX-240 | Belt FRM 11.2 | Special Order |
| Fisher TX-420 | Belt FRM 11.2 | Special Order |
If your turntable is not listed, first look for a close match in model number. Or, take careful measurements of your old belt's inside circumference, width and thickness.
Make the measurements with the belt lying flat and unstretched. Use a paperclip to mark your starting point. Measure in inches to match model; one inch=25.4mm. Also, make note of how loose the old belt is while installed in the turntable. Does it slip? How much side-to-side deflection is there in the open section between the spindle and the platter? Depending on how badly stretched out your old belt is, deduct 5 to 10 percent from the circumference. If the belt is broken or missing, use a piece of string (wrapped without slack, but not stretched) to measure the proper circumference, and then deduct 10 percent to allow the new belt to stretch into place. Go to the Belt Specifications Chart to find a suitable replacement.