Replacement Belts for Columbia Turntables Back to Belts Index Belt Specifications Chart TT Basics Home Page
<!--end title--!>
| Columbia 7049 | Idler Wheel IW08 | Special Order |
| Columbia 7074 | Idler Wheel IW08 | Special Order |
| Columbia 7076 | Idler Wheel IW08 | Special Order |
| Columbia 7083 | Idler Wheel IW08 | Special Order |
| Columbia Columbia 7539 | Idler Wheel IW08 | Special Order |
| Columbia 7542/A/B | Idler Wheel IW08 | Special Order |
| Columbia 7566 | Idler Wheel IW08 | Special Order |
| Columbia 7573 | Idler Wheel IW08 | Special Order |
| Columbia 7574 | Idler Wheel IW08 | Special Order |
| Columbia 7575 | Idler Wheel IW08 | Special Order |
| Columbia 8003-26 | Belt FRM 13.3 | Special Order |
| Columbia 8003-26 | Belt FR 14.1 | Special Order |
| IW08
ID=.153 in. OD=2.015 in. C/S=.409 in. |
If your turntable is not listed, first look for a close match in model number. Or, take careful measurements of your old belt's inside circumference, width and thickness.
Make the measurements with the belt lying flat and unstretched. Use a paperclip to mark your starting point. Measure in inches to match model; one inch=25.4mm. Also, make note of how loose the old belt is while installed in the turntable. Does it slip? How much side-to-side deflection is there in the open section between the spindle and the platter? Depending on how badly stretched out your old belt is, deduct 5 to 10 percent from the circumference. If the belt is broken or missing, use a piece of string (wrapped without slack, but not stretched) to measure the proper circumference, and then deduct 10 percent to allow the new belt to stretch into place. Go to the Belt Specifications Chart to find a suitable replacement.